Nylon Laserwash M5 Roller

This bridge roller is a replacement part for the Laserwash M5 automatic car wash. It is constructed with nylon and used to support the bridge trolley as it moves down the wash conveyor. The roller is located on the bottom of the bridge, and it helps to ensure that the trolley travels smoothly.

To replace the bridge roller, you will need to follow the instructions provided by the manufacturer. The process is typically easy.

Here are the steps involved in replacing the Laserwash M5 Bridge Roller:

• Disconnect the power to your Laserwash M5
• Remove the old roller
• Install the new roller
• Reconnect the power to the wash
• Please note there may be other steps involved

It is important to note that this bridge roller is a safety critical part for the Laserwash M5. If not properly installed, it could cause the bridge trolley to malfunction and potentially damage the vehicles of your customers. Therefore, it is important to follow the manufacturer instructions carefully when replacing this part.

Here are some additional tips installation and maintenance tips...

• Make sure the new roller is the correct size
• Lubricate the roller bearings to ensure smooth operation
• Tighten the mounting bolts to the specified torque
• Inspect for wear and tear regularly
• Replace the roller as needed

By following these tips, you can ensure that your Laserwash M5 car wash is operating safely and efficiently.

Specifications:

• Manufacturer: PDQ
• Part Number: VWS-46
• Part: Bridge Roller
• Compatibility: Laserwash M5